• Tidak ada hasil yang ditemukan

https://drive.google.com/file/d/0B9HTG AMkP1YM1VFZm0yU1h6UG8/view?usp=sharing

N/A
N/A
Protected

Academic year: 2017

Membagikan "https://drive.google.com/file/d/0B9HTG AMkP1YM1VFZm0yU1h6UG8/view?usp=sharing"

Copied!
6
0
0

Teks penuh

Loading

Gambar

Figure 1. General Structure of Fuzzy Logic Controller [9]
Table 1. FLC Rule Design
Figure 7.Mobile Robot Simulation with Obstacle
Figure 8. Speed Output without PSO-FLC
+2

Referensi

Dokumen terkait

In this work we have used an Agilent EXA Signal Analyzer N9010A controlled by the Agilent VSA 89600B software to measure the signal-to-noise ratio (SNR) and the error vector

The most important thing that has to consider in designing wheelchair for the stroke survivors is how accurate the classification to distinguish couple of

Abstract —This paper presents the development of PV (photovoltaic) simulator used for laboratory testing. The proposed simulator integrates both the software and the hardware

Then, a simulation program for the valve is developed based on the full mathematical model of the servovalve, using the measured physical parameter values and the

In this volumetric glassware calibration, parameters that influence the quality of the result which evaluated by using type B are mass of weighted water, air

The analysis of strain can’t be done via simple hand calculation due to the structural complexity of double end beam load cell, hence the finite element simulation

Results showed that the calculation with a cycle time of 140 seconds resulted the smallest total queue length of vehicles based on a comparison of the total queue length of

Temperature sensors are used for this study is NTC Thermistor temperature sensor (Negative temperature Coefficient) that temperature value is inversely proportional to