The major application was in creating the idols used for worship; and very strict rules were laid down to achieve perfection in terms of talmana (proportions), mudra (stance)

determined the design rules for the spherical bracket using investment casting.... Projek ini adalah khusus kepada garis panduan untuk proses

designed usfug one Computer Aided Design (CAD) tool wbich was CATIA V5Rl9. Hence, the analyses

Actuator Casting The manufacturing process of soft motor-tendon actuators using the casting method consists of several stages, including mold design, mold molding, material

73 5.2 Velocity of flow in multi number inlets vacuum manifold 73 5.3 Dynamic pressure distributed in multi inlets vacuum manifold 74 5.4 Mass flow rate of 4 inlets

This project presents the design and analysis of turbocharger by using

Therefore, this project was design, analysis and simulate of casting defect on water pump housing using casting simulation software..

This project is focusing on designing the mold design using SolidWorks software and the analysis of the filling time, solidification time and defects on the

Computer-Aided Design (CAD) and Computer-Aided Manufacturing (CAM) are the use of computer technology to help in design especially in drafting the technical drawing and

Thus, by using CAD software and the implementation of concurrent engineering improve the quality design of the plastic part and reduce the lead time, cost by reducing mold

This project includes the study on CAD software, Rapid prototyping techniques, Rapid tooling techniques such as silicon rubber mold and vacuum casting, and

The objective of this project is to estimate the most influential process parameters and process optimization in expandable mold casting which is sand casting using Bell

Besarnya sumbangan yang diberikan oleh variabel komunikasi interpersonal guru dan motivasi berprestasi secara bersama-sama terhadap sikap inovatif guru di SMA Negeri

For this project, a new design of cast MMC automotive wheel using aluminium A356 as binding material (matrix) and Silicon Carbide particles (reinforcement) will be

Manufacturing process contains many type of shaping processes. Sand casting process is one of the shaping processes. The cavity of the sand casting is made

The spin casting technology basically need a vulcanized mold to be placed into spin casting machine and also the silicone rubber as the material of the mold. The spin casting

Expendable mold with permanent patterns Lost foam Investment casting Replicast process Counter gravity with expandable patterns Bonded sand molding Green Sand CO2 Resin Bonded

The most common composite that has been used in manufactured this front bumper is Polymer-based composites, ThermoPlastic Olifen, and Carbon Fibre Reinforced for the