ANALISIS MATERIAL REMOVAL RATE (MRR) BAJA AISI H- 13 PADA PROSES EDM DIE SINKING MENGGUNAKAN ELEKTRODA TEMBAGA KROM
Teks penuh
Dokumen terkait
Therefore, a comprehensive study It was known that Beryllium Copper (BeCu) is used in using design of experiment (DOE) of the effect of EDM mould and die making for its high strength
a) To study the effect of machining parameters such as pulse on-time, pulse-off time, voltage and current on the EDM die sinking characteristics of Aluminium Alloy LM6.
This thesis discusses about the analysis of electrical discharge machine (EDM) die sinking parameters on the material removal rates (MRR) of mild steel.. Initially, five
Karbon juga digunakan sebagai elektroda EDM karena memiliki sifat tahan terhadap temperatur tinggi dan tidak terpengaruh oleh kejutan panas (thermal-shock)
Adapun tujuan dari penelitian ini adalah: (1) Mengetahui pengaruh arus listrik, off-time pulse, on-time pulse, dan Z down terhadap laju pengerjaan material dan
Skripsi berjudul ” Pengaruh Arus Listrik, Offtime Pulse, dan Discharge Gap pada Electrical Discharge Machining terhadap Laju Keausan Elektroda Chromium-
The higher the pulse-on time used in the EDM die-sinking machining process, the higher the average surface roughness value Ra so that the quality of the tungsten carbide material
The selected input parameters are Current, Pulse on time, and Pulse off time; and the outputs are Material Removal Rate, Electrode Wear Rate, and Surface Roughness.. The comparative
