EZ100PK PC/SC
Smart Card Reader
Installation Guide
V3.0
For Win2000
Version: 3.0
Date: July 31, 2001
Castles Technology Co., LTD. Tel: 886 (2) 8665-0530
Fax: 886 (2) 8665-0531
E-Mail: [email protected] Web: www.casauto.com.tw © Castles Techno logy Co., LTD.
Table Of Contents
WARNING ...3
ABOUT THIS MANUAL ...3
BEFORE INSTALLATION (IMPORTANT!):...4
EZ100PK PC/SC DRIVER INSTALLATION STEP-BY-STEP...5
Part 1:...5
WARNING
Information in this document is subject to change without prior notice.
No part of this publication may be reproduced, transmitted, stored in a retrieval system, nor translated into any human or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual, or otherwise, without the prior written permission of Castles Technology Co., LTD.
All trademarks mentioned are proprietary of their respective owners.
ABOUT THIS MANUAL
Before installation (Important!):
EZ100PK PC/SC Driver Installation Step-by-Step
Part 1:
Step1:
Plug the reader to PS/2 port.
Step2:
Step3:
When the welcome message shows, click <Next> button to continue.
Step4:
Step5:
Select “Add a new device”, then click <Next> button.
Step6:
Step7:
In "Hardware Type" page, select "Other devices", then click <Next> button.
Step8:
Step9:
Specify the path to “(CD-Rom Drive):\Drivers\EZ100PK\Win2k” then click <OK> button.
Step10:
Step11:
Click <Next> button to continue and follow the instruction shown in wizard.
Finish:
Part2:
Step1:
Step2:
Select “Keyboard” category, right click the keyboard installed, and select “Properties”.
Step3:
Step4:
When the welcome message shows, click <Next> button to continue.
Step5:
Step6:
Select “Show compatible hardware“ , and click <Have Disk> button to specify where the driver is.
Step7:
Step8:
Select "Keyboard that needs filtering for EZ100PK", then click <Next> button.
Step9:
Step10:
Click <Next> button to continue.
Step11:
Step12:
Click <Finish> to complete the upgrade driver.
Step13:
Step14:
Click <Yes> button to restart your computer.
Step15:
After system restart, you need to start the Smart Card Resource Manager.
To start the resource manager: 1. Login with Administrator.
2. Enter My Computer / Control Panel /Administrator Tools /Component Services
3. Find “Smart Card” service and Start it.
