Teks penuh
NPTEL - Mechanical Engineering - Forming
Joint Initiative of IITs and IISc – Funded by MHRD Page 1 of 3
NPTEL - Mechanical Engineering - Forming
Joint Initiative of IITs and IISc – Funded by MHRD Page 2 of 3
NPTEL - Mechanical Engineering - Forming
Joint Initiative of IITs and IISc – Funded by MHRD Page 3 of 3
Dokumen terkait
In the present work, the nonlinear C0 continuous finite element models based on non-polynomial 2D and quasi-3D higher order shear deformation theories in conjunction with Green-Lagrange
The extrusion behavior of an aluminum 356 alloy using the GISS technique is influenced by the plunger speed and the solid fraction of the slurry in the shot sleeve.. The higher solid
The shaft is designed to undergo elastic deflection during operation with stress much below the static tensile yield strength.. The shaft is subjected to shear stresses; and it is
Ceramic powder processing – Extrusion & Injection molding Extrusion – viscous mixture of ceramic particles, binder and other additives is fed through an extruder where continuous
cotlcItBIotts Acknowledgements Open die extrusion investigations on commercially pure titanium, AISI 1020 steel and commercially pure aluminium varying physical and mechanical
The red colour indicating the pressure is applied on the surfaces The maximum deformation takes place at the center of the casenub bogie because at the centre the pressure is
Key Engineering Materials, vol.594-595, 2014, pages 546-550 Effect of Surface Roughness of Pure Aluminium A1100 on the Cold Work Extrusion by Using Different Angles of Taper Die
It is found that the creep behavior under shear and normal stress or deformation imposition differ significantly: when viewed as a response in terms of a maximum shear description,
