• Tidak ada hasil yang ditemukan

IOT Based Thermal Screening using Raspberry Pi

N/A
N/A
Protected

Academic year: 2024

Membagikan "IOT Based Thermal Screening using Raspberry Pi"

Copied!
1
0
0

Teks penuh

(1)

IJARSCT

ISSN (Online) 2581-9429 International Journal of Advanced Research in Science, Communication and Technology (IJARSCT)

Volume 2, Issue 6, June 2022

Copyright to IJARSCT DOI: 10.48175/IJARSCT-5042 384 www.ijarsct.co.in

Impact Factor: 6.252

IOT Based Thermal Screening using Raspberry Pi

Ms. Prajakta Kulkarni1, Ms. Laxmi Alagi2, Ms. Dipali Anandpure3, Mrs. Arati Sudhakar4 Final Year Students, Department of Electronics and Telecommunications Engineering1,2,3

Faculty, Department of Electronics and Telecommunications Engineering4 SVERI’s College of Engineering, Pandharpur, India

Abstract: There are lots of IoT devices now days to monitor the temperature of patient over internet. Health experts are also taking advantage of these smart devices to keep an eye on their patients. With tons of new healthcare technology start-ups, IoT is rapidly revolutionizing the healthcare industry. Here in this project, we will make an IoT based thermal screening using raspberry pi. Is The Internet of Things (IoT) defines that objects are interconnected through wired and wireless networks without user intervention. MLX90614 is a contactless IR temperature sensor. It states that everybody radiates IR radiation proportional to its temperature. This radiation is then measured through the sensor converted to a digital signal and is communicated through the I2C bus and also the body temperature readings are recorded over ThingSpeak.

Keywords: Raspberry Pi, IoT, MLX90614 temperature Sensor

REFERENCES

[1]. Z. Zhiao, Chnaowei and z. Nakdahira, “Healthcare application based on Internet of Things”, Proc. IEET Int.

ConfE. on. Technolgy.Application., pp. 661-662, Nov. 2013.

[2]. Kortoom, Y. Kaiseer, N. Fittop and D. ramamoorthy, "Canny matters as construction brickss for application of Internet of Things", IEE-E Interne Networks andtComput., vol. 17.

[3]. A. Dohr, R. Modre-Osprian, M. Drobics, D. Hayn and G. Schreier, "The Internet of Things for Ambient Assisted Living", Seventh International Conference on Information Technology, 2010.

[4]. RajeevPiyare, “Internet of Things: Ubiquitous Home Control and Monitoring System using Android based Smart Phone”, International Journal of Internet of Things, 2013.

[5]. Rita Paradiso, Giannicola Loriga and Nicola Taccini, “ wearable health care system based on knitted integrated sensors”, IEEE transactions on Information Technology in biomedicine, 2005

Referensi

Dokumen terkait

memory space because it only captured a short video when a motion was detected. Method that will be used and apply towards completing development of the

Based on the findings and the discussions the writer concludes that the fourth semester students of English Department, academic year 2009/2010, Adab and Humanities Faculty of

Department of Physics Education, Faculty of Science and Mathematics, Satya Wacana Christian University, Salatiga, Indonesia1. Department of Physics, Faculty of Science and

209 APPLICATION OF PREGNANT MOM'S DIET BASED ON RASPBERRY PI USING TELEGRAM CHATBOT Yuli Wahyuni1, Fariz Ammar2, Irma Anggraeni3 Universitas Pakuan1 2 3 [email protected]

Engineering 2nd Year P1 Term Examination, 2018 Department of Electronics and Communication Engineering ECE2103 Digital Electronics and Logic Circuits TIME: 3 hours FULL MARKS: 210

VIII Abbreviations and Nomenclatures DUT – Device under Test FYP – Final Year Project GUI – Graphical User Interface HFM – High Frequency Measurement IOT – Internet of Things R&S

IoT-based Sensor System for Stop Line Traffic Area Using ATmega2560 Microcontroller Yamato Tan Department of Electrical Engineering Faculty of Engineering University of Pakuan Bogor,

Arsitektur rest API yang digunakan pada penelitian ini dapat dilihat pada Gambar 3, dimana transaksi yang terjadi pada sistem aplikasi yaitu komunikasi yang dilakukan dari aplikasi