• Tidak ada hasil yang ditemukan

Fabrication of single chamber microbial fuel cell (SMFC) using soil as a substrate

N/A
N/A
Info
Unduh - Bebas
Protected

Academic year: 2024

Membagikan "Fabrication of single chamber microbial fuel cell (SMFC) using soil as a substrate"

Copied!
1
0
0

Memuat.... (Lihat teks lengkap sekarang)

Unduh sekarang ( 1 Halaman )

Teks penuh

(1)

Fabrication of single chamber microbial fuel cell (SMFC) using soil as a substrate

ABSTRACT

This paper presents a Single-chamber Microbial Fuel Cell (SMFC) design by utilizing soil as a substrate with two sets of electrode combinations, which are graphite-activated carbon and copper-zinc of different sizes. It was found that graphite and activated carbon produced greater power density compared to copper and zinc. Moreover, it was observed that the graphite- activated carbon cloth electrode with a bigger surface area of 51cm2 resulted in a higher power density of 904mW/m2. To further improve the voltage production of this model, four SMFCs were stacked in series and connected to a DC-DC boost converter to increase the voltage to 1.482 V for the copper-zinc electrode and 1.722 V for the graphite-activated carbon electrode, respectively, which was sufficient to light up an LED light.

Referensi

Unduh sekarang ( PDF - 1 Halaman - 137.92 KB )

Dokumen terkait

View of PENGARUH BATANG FERRIT DAN BATANG CARBON TERHADAP PERFORMA MICROBIAL FUEL CELL DENGAN PIEZOELECTRIC MENGGUNAKAN LIMBAH TAHU CAIR

Cara ini akan menguji pengaruh variasi batang ferrit dan batang carbon terhadap performa microbial fuel cell dengan piezoelectric menggunakan limbah tahu

THE SOURCE OF ELECTRICAL ENERGY WITH MICROBIAL FUEL CELLS METHODTO USING BIO SLURRY AS LIGHTING OF HUMAN LIFE

Menurut (Aeltermn et al. 2006 dalam Zhang, 2012) microbial fuel cells (MFCs) adalah reaktor bioelektrochemical yang dapat mengkonversi energi kimia dari zat organik pada

Polymers as Proton Exchange Membranes and Challenges in Fuel Cell Application: A Review

Challenges in using PVA-based PEM in fuel cell applications To develop a new PEM for fuel cell applications, several specifications are required, namely, 1 low cost, 2 high thermal and

adsorption of a jet fuel on a model organic/clay soil

The soil was represented as an aqueous dispersion of the synthetic clay mineral Laponite coated with lysine, and the contaminant was a representative jet fuel, quadricyclane, mixed with

Recovery of soil microbial diversity and functions along a tropical montane forest disturbance gradient

Recovery of soil microbial diversity and functions along a tropical montane forest disturbance gradient ABSTRACT Logging and forest conversion are occurring at alarming rates in

A Study Review Between Ss430 and Crofer 22 Apu Solid Oxide Fuel Cell (SOFC) Interconnect After Spinel Coating Produced by Electrophoretic Deposition

The objectives for this research are to review the fabrication method of solid oxide fuel cell through stainless steel 430 SS430 and Crofer 22 APU as interconnect material mainly via

Engineering Model for Coupling an Electro–osmotic Fuel Micropump with a Miniature Direct Methanol Fuel Cell

Faculty, University of Tehran,[email protected] Abstract This paper presents a theoretical study of an active fuel delivery system for a miniature liquid feed direct methanol fuel cell

Bioelectricity Generation from Bamboo Leaves Waste in a Double Chambered Microbial Fuel Cell (Penjanaan Bioelektrik daripada Sisa Daun Buluh dalam Sel Bahan Api Mikrob Dua Kebuk) S

http://doi.org/10.17576/jsm-2023-5206-20 Bioelectricity Generation from Bamboo Leaves Waste in a Double Chambered Microbial Fuel Cell Penjanaan Bioelektrik daripada Sisa Daun Buluh