Characterization of Microstructure and Magnetic Properties of CaCu3Mn4O12 by Sol Gel Route.
Bebas
7
0
0
Teks penuh
Dokumen terkait
In order to enhance corrosion resistance of stainless steel, hydroxyapatite coating with and without presence of HCl catalyst prepared by sol-gel technique is being used
This specimen same as the pellets with 700 rpm stiring rate variation and 700º C sintering temperature, happens titanium cation reduction in compounds due to
Dari Tabel 4 tersebut, menunjukkan bahwa besarnya sifat magnetik ditentukan oleh banyaknya serbuk magnet SrM yang diikat oleh molekul polimer termoset, oleh sebab itu pengikatan
ABSTRACT Received 05/11/2015 Accepted 10/12/2015 Published online 01/01/2016 KEYWORDS FeVO4 Nanoparticle Solar cell Sonochemical method This research reports a facile ultrasonic
Figure 5.5 Hardness of a Al-5 WC, b Al-10 WC, c Al-15WC sintered preform 5.2 Wear and coefficient of friction analysis Abrasive wear behaviour of sintered specimens in
146 Characterisation and Thermal Properties of Titanium Dioxide Nanoparticles-Containing Biodegradable Polylactide Composites Synthesized by Sol–Gel Method Nikiwe Mhlanga1_ 2 and
Increase in nitrogen doping results in effective structural changes like decrease in FWHM of peak 34.30, appearance of additional peaks and removal of previous peaks.. The
3.2 Surface Morphology of Graphene Oxide/TiO2 Figure 2 shows micrographs of two different ratio of GO/TiO2 thin films which are 1:9GO/TiO2 and 1:20GO/TiO2 microstructure of the
