Quality of service for ad hoc on demand
Bebas
94
0
0
Teks penuh
Gambar
+7
Garis besar
Dokumen terkait
The message package contains the source node ID, destination node ID, number of hops, node’s ID through the path, bandwidth required, message length and flow load ability(flow
(b) Node classification based on destination. If such a delay is large, a routing failure or a route discovery failure may occur because the destination may have
So even if a source node has a valid route recorded (link state) or cache (on demand) it is not necessary there is no guarantee that the route will always be available
❍ If both conditions are met & the IP address of the destination matches with that in RREQ Æ the node responds to RREQ by sending a RREP back using unicasting and not
In particular, the protocol is modified to send out the RERR packet when the monitored link quality (RTQ) to the next hop node drops below RTQ THRESHOLD. Since the connectivity
If afterwards source receives RREP having a greater sequence number or contains the same sequence number but with a smaller path length, then source update its routing
In the communication after 5 ms second each and every node send route checker packet to the next to the next node and a route checker packet receiving node checks that the data
Route repair is the responsibility of a source node after receiving a warning about the imminence of a link break on an active route to a destination.. This mechanism has been applied
