Competitor Station No. :_____________________
MECHANICAL ENGINEERING DESIGN - CAD
Module 2 – Day 3
Mechanical Fabrication – 4 hours
INSTRUCTIONS
1. Do not open this question paper until you are told to do so. 2. Write your Station Number clearly at the top right-hand corner
on the front page of this question paper.
3. Return this question paper at the end of the test.
Task : Mechanical Fabrication. Time Allocation : 4 hours
I. Introduction
A company is developing a ………. You will model components of as subassembly for the assembly.
II. Description of Project and Tasks
Review the PDF and prints of the assemblies for ……….. You should also create a sheet metal parts, assemblies, and functional animations of the assembly.
III. Task
Create assemblies using parts you have created or found in the project folder.
1. Create “Sub-Assembly 1” (based on printed document in 3D view)
2. Create “Sub-Assembly 2” (based on printed document in 3D view)
3. Create “Sub-Assembly 3” (based on printed document in 3D view)
4. Create “Sub-Assembly 4” (based on printed document in 3D view)
IV. Create an Animation
a) Using Autodesk Inventor Studio, create a rendered image of the complete assembly as follows:
1. Image size : 1024 x 768 pixels;
2. Select a Camera, Light style, and Scene style to best represent the assembly.
b) Using Autodesk Inventor Studio, create an animation as follows:
1. Screen size: 1024 x 768 2. Length : 20 seconds
3. From 0 to 8 seconds Motion 1 4. From 9 to 12 seconds Motion 2 5. From 13 to 15 seconds Motion 3 6. From 15 to 20 seconds Motion 4
V. Output
Save your drawing in folder My Documents: \MED-CAD-LKS SMK NASIONAL 2017\Module 2\Competitor Name\name of the component.
