The formation of (2-fluorophenyl)(2,4,6-trimethoxyphenyl)methanone (3.58) was successful as confirmed by the 1H NMR spectrum (Plate 3). The methoxy protons are more shielded and as a result they resonate upfield, 2,6-OCH3 and 4-OCH3 appearing at δH 3.67 and δH 3.83, respectively. The methoxy groups are electron donating which causes the aromatic protons (H-3 and H-5) to resonate upfield (δH 6.12) relative to the protons in the monofluorinated aromatic ring. The ortho (H-13) and para (H-11) are the most deshielded protons (δH 7.75 and δH 7.43, respectively) in the ring because of the mesomeric effect caused by the carbonyl group (as shown in Scheme 3.25). In addition to the mesomeric effect, H-13 experiences a greater negative inductive effect from the carbonyl group than H-11 as a result H-13 is shifted further downfield. The meta protons (H-10 and H-12) were the most shielded protons in the fluorinated benzene ring, at δH 7.01 and δH 7.15, respectively. Coupling was observed in the spectra in Table 3.1 and the coupling constants are given in Table 3.2.
47 | P a g e
Table 3.1: Aromatic region of the 1H NMR spectra of the fluorinated benzophenones.
Chemical structure Aromatic region of the 1H NMR spectra
R F O
3.58
R O F
3.59
R O
F 3.60
The 13C NMR spectrum of (2-fluorophenyl)(2,4,6-trimethoxyphenyl)methanone (Plate 3) also supports the structure with a carbonyl carbon peak at δC 190.7. As a result of the high electronegativity of fluorine, the fluorine-containing carbon (C-9) resonates downfield at δC 160.4 relative to C-13 which resonates at δC 131.4 (∆δ = 30 ppm). The carbon peaks in this ring were all split due to coupling to the fluorine. The magnitude of the 19F,13C coupling constants depend on the number of bonds between the fluorine and the carbon, for example the ipso carbon (C-9) has 1J = 256.5 Hz (one-bond coupling with fluorine).
The J-values decrease as the number of bonds increase as shown in Table 3.2.
The structure of (2-fluorophenyl)(2,4,6-trimethoxyphenyl)methanone (3.58) was also confirmed by the high-resolution mass data which shows a good agreement between the calculated mass for the sodium adduct of 313.0852 (C16H15O4FNa) and an observed molecular ion peak at m/z 313.0849 [M+Na]+.
7.0 7.1 7.2 7.3 7.4 7.5 7.6 7.7 7.8
7.9 ppm
7.3 7.4
7.5
7.6 ppm
7.2 7.4
7.6
7.8 ppm
48 | P a g e
Table 3.2: 1H and 13C NMR data for the fluorinated aromatic rings of 3.58, 3.59 and 3.60.
Compound No:
Protons and carbons of the fluorinated aromatic rings
H-8/C-8 H-9/C-9 H-10/C-10 H-11/C-11 H-12/C-12 H-13/C-13 3.58
…………
δC 127.9 d, J =9.5
………….
δC 161.7 d, J = 256.5
δH 7.01 dd J = 11.4,8.5
………….
δC 116.3 d, J = 22.8
δH 7.43 m
………….
δC 133.8 d, J = 9.1
δH 7.15 t J = 7.7
…………
δC 123.8 d, J =3.9
δH 7.75 dd J = 7.7, 7.6
………….
δC 131.4 d, J = 1.4 3.59
…………
δC 140.6 d, J = 6.2
δH 7.51 dt J = 9.3, 1.8
…………..
δC 115.9 d, J = 22.4
………….
δC 162.8 d, J = 246.6
δH 7.37 m
………….
δC 119.7 d, J = 21.5
δH 7.21 td J = 8.2, 2.8
………….
δC 129.8 d, J = 7.5
δH 7.60 dt J = 8.2, 1.8
………….
δC 125.1 d, J = 2.8 3.60
…………
δC 134.9 s
δH 7.85 dd J = 8.6, 5.7
………….
δC 132.0 d, J = 9.4
δH 7.07 dd J = 9.2, 8.6
…………..
δC 115.3 d, J = 22.0
………….
δC 165.8 d, J=154.8
δH 7.07 dd J = 9.2, 8.6
…………..
δC 115.3 d, J = 22.0
δH 7.85 dd J = 8.6, 5.7
………….
δC 132.0 d, J = 9.4
The Friedel-Crafts acylation was also applied to synthesize (3-fluorophenyl)(2,4,6- trimethoxyphenyl)methanone (3.59) and (4-fluorophenyl)(2,4,6- trimethoxyphenyl)methanone (3.60) where 3-fluorobenzoyl chloride and 4-fluorobenzoyl chloride were used, respectively, to react with 1,3,5-trimethoxybenzene. These reactions were highly successful and gave good yields of up to 95% as shown in Table 3.4. The 1H NMR spectra of these benzophenone derivatives showed interesting proton splittings as a result of the position of the fluorine (shown in Table 3.1). In general, the coupling constant for 1H to the neighboring 19F is always bigger than the coupling constant between 1H and the neighboring 1H on the related position. For example, for the 2-fluoro substituted derivative (3.58), the ortho coupling constants (J values) for H-10 to 9-F and H-11 are 11.4 Hz and 8.5 Hz, respectively as shown in Table 3.2.
49 | P a g e
Table 3.3: Splitting observed in the 19F NMR spectra due to 1H, 19F coupling.
Compound 19F NMR Spectrum
3.58
3.59
3.60
The 19F NMR spectra were run for all the fluorinated benzophenones to verify the position of fluorine in each structure. Because of its ability to couple with the neighboring carbons, the splitting varies from the ortho, meta and para substituted fluorine as shown in Table 3.3.
Table 3.4: Percentage yields and physical properties of the synthesized benzophenones.
3.32 3.57 3.58 3.59 3.60
Yield 90% 92% 94% 95% 95%
Melting point 112-114 °C 95-96 °C 127-129 °C 107-109 °C 155-157 °C Appearance Colourless
crystals
Colourless crystals
Colourless crystals
Colourless crystals
Colourless crystals
-113.40 -113.45 -113.50 ppm
2-F
-113.1 ppm
3-F
-105.9 -106.0 ppm
4-F
50 | P a g e
All the synthesized fluorinated benzophenones were fully characterized by other techniques such as IR, HRMS and melting points. Their IR spectra look similar to that of phenyl(2,4,6-trimethoxyphenyl)methanone (3.32) as they all show strong carbonyl peaks within a carbonyl range (1600 - 1700 cm-1). The melting point for the para-substituted benzophenone (3.60) was the highest (155 °C - 157 °C), followed by the ortho-substituted fluorine derivative 3.58 (127 °C - 129 °C).
The results discussed above show that the Friedel-Crafts reaction can be applied for the acylation of phloroglucinol derivatives to form benzophenones as it gave good yields (90%
- 95%). AlCl3 has also proved to be a good Lewis acid for this type of acylation reaction.
All benzophenone derivatives were obtained as colourless crystals.
3.4.6 Synthesis of phenyl(2,4,6-trihydroxyphenyl)methanone (3.33)
The third step was the demethylation of the methoxy groups of the aromatic ring using a strong Lewis acid (boron tribromide, BBr3).138,139 BBr3 has been used to cleave ethers and acetals that cannot be deprotected by the use of a normal acid.140 This use of BBr3 for aryl deprotection in this research was preferred over the other methods because the reaction proceeds under mild conditions. This reaction was carried out in dichloromethane at -78 °C with 5 equivalents of BBr3 added quickly to the solution of 3.32 (Scheme 3.28). The reaction was stirred at room temperature for 24 h, resulting in a complete demethylation.When the reaction was run for 10 h, the TLC showed some spots with higher Rf values which may be due to partially demethylated products. After isolation, NMR analysis revealed the existence of some methoxy peaks in the structure. With longer reaction time, the yield of these side products was decreased. After monitoring a few reactions, it was found that the average time to complete the reaction was 24 h and yields up to 99% were observed.
OH
OH O
H
O
3.32 5
3 1
12 7
OMe 9
OMe MeO
O