• Tidak ada hasil yang ditemukan

Heat Calculations for Various Substances

N/A
N/A
Nino Munawanto ninomunawanto.2023

Academic year: 2024

Membagikan "Heat Calculations for Various Substances"

Copied!
1
0
0

Teks penuh

(1)

1. A mass of 2 kg of water is at a temperature of 20°C and is heated to a temperature of 80°C.

If the specific heat capacity of water is 4200 cal/kg °C, determine the amount of heat required, stated in calories!

2. 2 kg of ice is heated until it melts according to the following graph!

If:

specific heat capacity of water = 4200 J/kg°C, specific heat capacity of ice = 2100 J/kg°C, heat of fusion of ice = 330,000 J/kg, heat of vaporization = 540 J/kg°C,

Calculate the heat required on the graph:

a. A-B b. B-C c. C-D d. A-D

3. A mass of 0.1 kg of water at 20°C is heated until it boils at 100°C. If the specific heat capacity of water is 4200 J/kg°C, then the amount of heat required is...

4. A 2 kg aluminum rod undergoes a temperature increase of 25°C. If the specific heat capacity of aluminum is 900 J/kg°C, then the amount of heat required for the process is...

5. A 4 kg iron with a temperature of 20°C is heated with 92000 J of heat. If the specific heat capacity of iron is 460 J/kg°C, then the temperature of the iron after heating is...

6. A hot piece of iron weighing 1 kg and at a temperature of 100°C is placed into a container containing 2 kg of water at 20°C. If the specific heat capacity of iron is 450 J/kg°C and the specific heat capacity of water is 4200 J/kg°C, then the final temperature of the mixture is..

Referensi

Dokumen terkait

Effect of Heat Treatment Conditions on Aluminum Alloy 6061.. This report submitted in accordance with requirement of the

Heat recovery system will be mount at the exhaust’s pipeline of car and heat waste from exhaust will be absorb by the hot side of Thermoelectric module and coolant like water

(i) Rolled Products - Aluminum sheet applications include heat exchangers, heat shields, bumper stock as well as closure sheet and structural sheet for complete

In this chapter, it will present about properties of Aluminum and Aluminum Alloy 7075. We also discuss the effects of different types of heat treatment process that will involve on

The separate type HPHE shown in F i g u re 6b is essentially similar to the Figure 4: Typical heat pipe for semi conductor cooling Figure 5: Schematic layout of a heat pipe solar water

Appendix B Supplementary material for Chapter 5: Melt constraints on the geothermal heat flux beneath the Antarctic Ice Sheet B.1 Creating Ice Geothermal Profiles This supplement

of single glass [U value of 1.13] with an inside temperature of 70°F and an outside temperature of 0°Fwould have 791 BTUH heat loss: A 10 x U 1.13 x ∆T 70 = 791 Btu/hr Since the

To begin with, establish a constant temperature gradient in a metal rod with the use of two heat reser- voirs boiling water and ice water After removing the pieces of ice, measure the