Design and simulation of die and punch for sheet metal on bending.
Bebas
24
0
0
Teks penuh
Gambar
+3
Dokumen terkait
Overall project benefit is sheet metal cutting improving from user aspect, design aspect and ergonomic aspect prevention long term and short term musculoskeletal problem to
However, none of the authors cited above used a simulation in designing of compressor impeller by using metal matrix composite and investment casting.. This research will
The experimental results showed that the temperature distribution along wall surface of evaporator section for ethanol charged pipes was higher than that of water charged
Based on the test results, the bending angle on the soft PBA shows that the bending angle of unattached PBA on the human finger has higher bending angle than the PBA attached on the
Predicted heat flux, in particular, at the outer zone of reactor vessel with focusing effect of metal layer of corium formed in the inner vessel is beyond the critical heat flux under
Keywords: metal deck; rib height; bending capacity; elastic section modulus; optimization Introduction Over the past few decades, steel and concrete have been widely used in
The document presents a research on the design and development of a fatigue machine for conducting rotating bending fatigue testing on different
