CFD Simulation Of A Direct Injection Natural Gas Injector Nozzle.
Bebas
24
0
0
Teks penuh
Dokumen terkait
The alternate arrangement of tray position was adopted to ensure that all trays are exposed directly to drying air and to improve airflow distribution throughout the drying
It can be seen that from Fig.4(a) the relation between LNG temperature and vapor formation. As expected, vapor formations are larger near the wall of the LNG tank due to higher
Here, split injection Nomenclatures Abbreviations Definitions ET Energizing time DT Dwell time IR Injection rate p Pressure prail Nominal rail pressure prailpipe Actual pressure
Page 15 © CSIR 2006 www.csir.co.za Adaptive optics for turbulence correction • SLM acts as an adaptive optic • Measure wavefront distortion, • Feed result back into SLM to create
Hosseini1 1 Department of Mechanical Engineering, Dezful Branch, Islamic Azad University, Dezful, Iran ARTICLE HISTORY Received: 21st Aug 2020 Revised: 21st Jan 2021 Accepted: 17th
heat transfer coefficient with the increasing particle fractionAl2O3 Fig.10 Change of average heat transfer coefficient with the increasing particle fractionCu A relationship between
The results of the injection pressure sensitivity in FIGURE 1 indicate that the optimum injection pressure in the gas cap zone for sub-layer A-1 is 679 psi TABLE 3.CO2Injection
