Let’s Make Your Animal Origami Monkey
Start with a square of origami paper, colored side up.
Make a valley fold along the east-west axis, and also one along north-south, as shown. Then fold point A up to the center:
Now fold point B to the left, so that edges BC and CD meet, then unfold:
Now fold corner E to the right as shown:
Then repeat the steps in the last ten (10) photos on the left side of the origami piece.
Now place a finger in one of the front pockets, and fold down as shown:
Now open the top pockets as shown in the next four (4) photos. The top part of the model will not lie down flat after this step:
Now make a swivel fold on each of the front flaps. Start by rotating the line HI by a few degrees as shown, then re-crease the left flap:
Now repeat that swivel fold on the right side. Then fold the bottom part of the piece up, allowing the flap in the back to swing to the front.
Now fold corner J upwards as shown, then make a valley fold to move J back down:
Fold point J under as shown, then fold the tip of the monkey's nose over:
Next we create the monkey's eyes. Fold corners K and L down and back as shown:
We'll show the next seven (7) steps on the left eye. Valley fold and unfold as shown, then do a squash fold. A paperclip or toothpick will help here.
Now your origami monkey is complete!
Cat
Start with a square 6" x 6" (15cm x 15cm) piece of paper. Fold and crease it along the diagonal like so:
Now unfold the triangle so it lays flat again. Then fold each corner upwards to make the ears:
Now fold the top corner over towards you:
Dog
Origami Dog Step 1: Start with a square piece of paper. If it is colored paper, put the colored side face down on the table as shown below. Then fold along the diagonal to give a triangle.
Origami Dog Step 3: Next fold the top and bottom of the head, away from you. The dog is done! If you like, you can draw eyes, a nose and a mouth.
Panda
Origami Panda Step 1: Start with a square origami paper color side down.
Origami Panda Step 2: Fold in half on both diagonals so that you get 2 intersecting creases like this.
Origami Panda Step 4: Open the folds back up.
Origami Panda Step 5: Fold the left and right tips to meet the crease in the center:
Origami Panda Step 6: Flip the paper over:
Origami Panda Step 8: Make a fold at the dash line, approximately 2 cm from the center crease.
Origami Panda Step 9: Almost done! You can see "Po's" face already! Fold at the dash line shown below.
Origami Panda Step 10: Now, just fold the bottom tip up to meet the crease.