• Tidak ada hasil yang ditemukan

Modeling and Controller Design of an Electro-Hydraulic Actuator System.

N/A
N/A
Protected

Academic year: 2017

Membagikan "Modeling and Controller Design of an Electro-Hydraulic Actuator System."

Copied!
9
0
0

Teks penuh

Gambar

Fig. 2: Multi sine signal with three different frequencies
Fig. 3: The input-output data of EHA system
Fig. 11: System with PID controller with sine input
Fig. 16: Response of real-time PID controller with sine input (experiment)

Referensi

Dokumen terkait

In this paper, the PID controller that intact with self tuned nonlinear gain (known as NPID) is proposed and tested to control the position and tracking of XY table ballscrew

The development of an upper limb robotic arm is passively important and needed to research based on the type of application perform, actuator and the controller.. The

The performance Fuzzy Logic controller then will be compare with the Linear Quadratic Regulator (LQR) and the passive suspension system in term of its body

state-feedback controller and lead/lag controller will be designed in order to control

This study discusses testing the web tension on the Rewinder Roll system using the Auto-TuningPI controller using Fuzzy Logic Controller with the Fuzzy Mamdani method and the

3 Micro-beam’s response to shock input without controller or actuation signal interference, a Micro-beam’s response to half-sine shock pulse of 1000g amplitude, b Micro-beam’s response

The designed DDR Controller supports data width of 64 bits, Burst Length of 4 and CAS Column Address Strobe latency of 2.DDR Controller provides a synchronous command interface to the

It can be summarized that the proposed controller successfully minimize the steady-state error, improved the settling time and reduce the overshoot of the pneumatic positioning response