56
DAFTAR PUSTAKA
[1] Varaprasad.Bh, Srinivasa Rao.CH, P.V. Vinay., 2014, “Effect of
Machining Parameters on Tool Wear in Hard Turning of AISI D3 Steel”, Global Congress on Manufacturing and Management, GCMM 2014
[2] Suha K. Shihab, et al, “RSM Based Study of Cutting Temperature during Hard Turning with Multilayer Coated Carbide Insert”, International Conference on Materials Processing and Characterisation, IC MPC 2014
[3] SatishChinchanikar, S.K Choudhury, “Evaluation of Chip Tool Interface Temperature: Effect of Tool Coating and Cutting Parameters during Turning Hardened AISI 4340 Steel”, International Conference on Materials Processing and Characterisation, ICMPC 2014
[4] Atul P. Kulkarni, Girish G. Joshi, Vikas G. Sargade, “Dry Turning of AISI304 austenitic stainless steel using AlTiCrN coated insert produced by HPPMS technique”, International Conference on Design and Manufacturing, IConDm 2013
[5] Douglas C. Montgomery. 2012. Design and Analysis of Experiments,
Arizona State University. John Wiley & Sons, Inc.
[6] Kalpakjian, Serope and R.Schmid, Steven. 2009. Manufacturing Engineering and Technology, sixth edition. New York: Prentice Hall.
[7] De Garmo, 2008. Materials And Processed in Manufacturing, tenth edition. John Wiley& Sons, Inc.
[8] S. S. K.Deepak, “Cutting Speed and Feed Rate Optimization for Minimizing Production Time of Turning Process”, International Journal of Modern Engineering Research (IJMER). Vol.2. Issue.5. Sep-Oct. 2012 pp-3398-3401
[9] Christian Aidy Mosey, Rudy Poeng, Johan C. Neyland, “Perhitungan Waktu dan Biaya Pada Proses Pemesinan Benda Uji Tarik
[10] Rochim, Taufiq. 2001. Spesifikasi, Metrologi, dan Kontrol Kualitas Geometrik. Institut Teknologi Bandung.
[11] Rochim, Taufiq. 1993. Teori dan Teknologi Proses Pemesinan. Institut Teknologi Bandung.
