PAPER TITLE
A. Unknown, Naval Architecture Department, Diponegoro University
B. Goodman & C. Fineman, Naval Architecture Department, Diponegoro University
ABSTRACT
This document is the Microsoft Word template for the Journal of KAPAL. The formatting and arrangement of this text conforms exactly to the requirements for all Technical Paper submissions. All papers require an Abstract section at the beginning; this is a brief description of the scope of the work. This first section of the paper takes 16 cm of the page and is 1 column, Font 10, Times New Roman, Aligned Justified, as this paragraph. The subsequent sections should use a two-column setup, as below with Font 12, Times New Roman, Regular, Justified. If you need to alternate between full width and two-columns (perhaps to insert large pictures or tables) use ‘Continuous Section Breaks’ to separate the text. The Styles and Formatting toolbar (which has been pre-set in this document) can be activated using the button in the top toolbar marked with a blue ‘double-A’ symbol. Formatting within the document can be made visible by using the button in the top toolbar marked with this symbol.
NOMENCLATURE
This is required for all papers using a large number of symbols, abbreviations or acronyms. From this point onwards the rest of the document is in this paper is limited up to maximum of 10 pages.
2. HEADING
The heading should be in BOLD CAPITAL, Font 12, Times New Roman.
2.1 SUB-HEADING
Sub heading should be Regular, CAPITAL, Font 12, Times New added manually and a single ‘tab’ used to space out the title.
3. LISTS
Bullet points should be used for lists:
Not numbers or letters
-Hyphens are used for second-level indents bottom of each figure in Font 10, Times New Roman, Regular. Similarly for the Table, Table No and other information should be mentioned on the Top of the table, Font 12, BOLD, Times Roman.
5.
CONCLUSION S
The main body of the text must end with the conclusions of the paper.
ACKNOWLEDGE MENTS
Brief
