Vol 11, No 2 (2015) 1 of 1 05/09/ :54 JURNAL APLIKASI FISIKA. Home > Archives > Vol 11, No 2 (2015) ISSN: OPEN JOURNAL SYSTEMS

(1)

OPEN JOURNAL SYSTEMS Journal Help USER Username Password Remember me Log In NOTIFICATIONS View Subscribe / Unsubscribe JOURNAL CONTENT Search All Search Browse By Issue By Author By Title Other Journals FONT SIZE INFORMATION For Readers For Authors For Librarians

HOME ABOUT LOG IN REGISTER SEARCH CURRENT ARCHIVES

Home > Archives > Vol 11, No 2 (2015)

Vol 11, No 2 (2015)

JURNAL APLIKASI FISIKA

TABLE OF CONTENTS

ISSN: 1858-4020

si Fisika (JAF) Jurusan Fisika UHO-KENDARI --- Jurnal Aplika http://ojs.uho.ac.id/index.php/JAF/issue/view/203

(2)

Home > Archives > Vol 11, No 2 (2015)

Vol 11, No 2 (2015)

JURNAL APLIKASI FISIKA

Table of Contents

VOLUME 11 NO. 2, AGUSTUS 2015

ANALISIS PROKSIMAT DAN NILAI KALOR BRIKET HIBRID (BROWN COAL – SEKAM PADI) DENGAN PEREKAT LIQUID VOLATILE MATTER (LVM) YANG DIPREPARASI DENGAN METODE PIROLISIS

PDF

Rahmat ., H.M. Jahiding, E.S. Hasan

PRODUKSI DAN KARAKTERISASI SENYAWA LIQUID VOLATILE MATTER AMPAS SAGU MENGGUNAKAN METODE PIROLISIS DAN GAS CHROMATOGRAPHY

PDF

Muhammad Jahiding, W.O.S. Ilmawati, M. Burhan

THEORETICAL ANALYSIS OF MICROWAVE SINTERING OF CERAMICS PDF

Muhammad Zamrun F

PENGARUH TEMPERATUR KALSINASI TERHADAP KAPASITANSI SUPERKAPASITOR PADA KOMPOSIT TIO2-ARANG AKTIF KULIT BIJI METE

PDF

Muhammad Anas, Hajjah Hunaidah

PERCEPATAN REAKSI KIMIA DENGAN PEMANASAN MIKROWAVE PDF

I Nyoman Sudiana, Muhammad Zamrun Firihu

Ponderomotive Force Generated by Microwaves During Sintering PDF

Muhammad Zamrun F, I Nyoman Sudiana ISSN: 1858-4020

urnal Aplikasi Fisika (JAF) Jurusan Fisika UHO-KENDARI --- J http://ojs.uho.ac.id/index.php/JAF/issue/view/203/showToc

(3)

Home > Vol 11, No 2 (2015) > Zamrun F

Ponderomotive Force Generated by Microwaves During Sintering

Muhammad Zamrun F, I Nyoman Sudiana

Abstract

Dalam beberapa tahun terakhir, banyak peneliti telah melaporkan pengamatan dari "efek microwave" di berbagai proses material seperti pada sintering, annealing, sintesis, Istilah efek microwave tidak didefinisikan secara ketat. Sering digunakan untuk menandai perbedaan hasil ketika pemanasan microwave digunakan dibandingkan dengan pemanasan biasa dengan pemanas listrik atau gas. Efek microwave dapat dijelaskan dalam dua kategori yakni efek termal dan efek non termal. Banyak hasil eksperimen menunjukkan adanya efek nonthermal dari microwave yang meningkatkan laju difusi atom di zat padat. Dalam teori sintering, atom berpindah karna adanya gaya pemicu (driving force) sebagai penyebabnya misalnya karna perbedaan tekanan permukaan, suhu, gravitasi, dll. Para ahli meyakini bahwa selama pemanasan dengan microwave ada gaya tambahan yang menyebabkan atom berdifusi lebih cepat akibat kehadiran medan listrik yang dinamai ponderomotive force. Dalam tulisan ini dibahas gaya ini terkait data ekperimen yang telah diperoleh beberapa tahun terakhir.

Full Text: PDF Refbacks

There are currently no refbacks.

Ponderomotive Force Generated by Microwaves During Sintering | Z... http://ojs.uho.ac.id/index.php/JAF/article/view/1279

(4)

JURNAL APLIKASI FISIKA VOLUME 11 NOMOR 2 AGUSTUS 2015

Ponderomotive Force Generated by Microwaves During Sintering

M. Zamrun Firihu dan I.N. Sudiana

Jurusan Fisika, Fakultas Matematika dan Ilmu Pengetahuan Alam, Universitas Halu Oleo, Kendari, Sulawesi Tenggara, 93231

E-mail : muhammad.zamrun@uho.ac.id

ABSTRAK

Dalam beberapa tahun terakhir, banyak peneliti telah melaporkan pengamatan dari "efek microwave" di berbagai proses material seperti pada sintering, annealing, sintesis, Istilah efek microwave tidak didefinisikan secara ketat. Sering digunakan untuk menandai perbedaan hasil ketika pemanasan microwave digunakan dibandingkan dengan pemanasan biasa dengan pemanas listrik atau gas. Efek microwave dapat dijelaskan dalam dua kategori yakni efek termal dan efek non termal. Banyak hasil eksperimen menunjukkan adanya efek nonthermal dari microwave yang meningkatkan laju difusi atom di zat padat. Dalam teori sintering, atom berpindah karna adanya gaya pemicu (driving force) sebagai penyebabnya misalnya karna perbedaan tekanan permukaan, suhu, gravitasi, dll. Para ahli meyakini bahwa selama pemanasan dengan microwave ada gaya tambahan yang menyebabkan atom berdifusi lebih cepat akibat kehadiran medan listrik yang dinamai ponderomotive force. Dalam tulisan ini dibahas gaya ini terkait data ekperimen yang telah diperoleh beberapa tahun terakhir.

Keywords: efek mikrowave, efek nonthermal, poderomotive force, difusi atom

I. INTRODUCTION

Many researchers have reported observations of "microwave effects" in a variety of material processes [1-3]. Microwave effect is sometime used to mark the enhancement of the processing rate when microwave heating is utilized such as enhancement of densification, atomic diffusion, chemical reaction rate [3]. In principle, the potential benefits of microwave heating, caused by the volumetric nature of microwave energy

deposition which provides, in particular, a possibility of faster and more controllable temperature ramp-up and its selectivity which can provide concentration of energy deposition in the desired region result in precision heating. All the listed peculiarities of microwave heating can be treated as the thermal action of the electromagnetic field on matter. All microwave effects can be explained specifically to thermal and nonthermal effect.

(5)

Ponderomotive Force………(Zamrun,dkk)

Numerous experimental results suggest existence of a specific nonthermal action of microwaves on mass transport in crystalline solids [4]. The characteristics of porosity under microwave heating were found to differ considerably from those observed in a conventional sintering process under the same conditions. A direct influence of the microwave field on the transport phenomena in crystals was found in investigations of atomic diffusion [1], as well as in a study of the observation of a quasi-stationary electric current induced in a dielectric subjected to pulsed microwave irradiation [5]. However, the physical mechanisms of the effect are not completely clear. Some researchers proposed the additional driving force exist during microwave processing. Especially, Rybakov and Semenov proposed the first model being able to explain quantitatively the existence of an additional driving force for transport

processes in ionic crystals subjected to a microwave field [4]. The basic idea was comparatively simple, based on the effect of rectification of the oscillatory vacancy drift near grain boundaries and interfaces. The additional driving force is known as ponderomotive force.

II. RESULTS OF MICROWAVE PROCESSING OF MATERIAL

Microwave enhanced sintering has been reported by several scholars [1-3,6-7 ]. It has received much attention because of the observed substantial decrease in sintering temperature and fast heating rates. Tian, et al.[6], have performed sintering of alumina at 1700 oC for 12 minutes. They reported that the sintered samples achieved 99.8% of theoretically density, with fine grain of 1.9 m. The effect of microwave is not only in ceramic processing. Microwave enhanced drying have been also reported [8-9]. Some microwave enhancement results are shown in Fig 1 to 3.

Fig. 1. Drying curves of cocoa beans in a microwave and in an electric furnace [8] 45

(6)

JAF Vol 11 No. 2 (2015) 48-52

Figure 2. Effect of microwave frequency and green sample in microwave sintering alumina [10]

Fig. 3 Reduction of open and closed porosity of silica xerogel upon MMW as compared to conventional sintering [2]

III. DISCUSSIONS

Because of all results are temperature activation process, they can be associated to enhancement of diffusion. Sintering lowers the surface energy of material by reducing surface area with concomitant formation of interparticle bonds. During sintering, high-energy

free surfaces are replaced by lower energy sites such as grain boundaries or crystalline regions. The formation of these low-energy sites (neck region), and subsequent reduction in surface area. This reduction results in a decrease in the overall surface energy and known as driving force:

(1)

(7)

JAF Vol 11 No. 2 (2015) 44-48

where G is free energy, s is specific

surface energy, and A is surface area. The stress associated with the curved surface as

(2) where R1 and R2 are principal radii of

curvature for this surface.

Flux of atom, J, is product of inter atomic distance, reaction rate constant, and diffusing concentration.

Diffusion path of mass transport during sintering of crystalline materials can occur by at least six mechanisms: vapor transport (evaporation/condensation), surface diffusion, lattice (volume) diffusion, grain boundary diffusion, and plastic flow [25].

Figure 4. Possible atomic diffusion ways during sintering [10]

The enhancement shown in Figure 1-3 reported by researchers is indicated that microwaves enhanced diffusion rate (mass transport flux) during processing.

For drnsification, by simplifying of diffusion process using two particle model the relation of densification to material transport parameters can be expressed by following equation:

ziF rmscRT2πVmx2a33/2t3/2 (3)

Where = density, L= material dimension, Q= activation energy, R is the universal gas constant, T=temperature, Do is diffusion constant,

s is specific surface energy, zi = charge

on the ion, F =Faraday constant = 9.65 kJ/ V, Erms = root mean square of the

electric field of microwave, A is the cross-sectional area over which diffusion occurs and Vm is the molar

volume of the material being transferred, x is radius of neck, a is radius of particle, and t is time. Component is microwave contribution on

atomic transport during sintering. It is driving force generated by electric field of microwaves. It should enhanced atomic transport during sintering. Application of ponderomotive effect was shown in experiment performed by Rybakov [11]. It was shown that a microwave field with the E-vector directed tangentially to a surface of a solid can develop a deformation-type instability. This results in the formation of a corrugated profile on that surface with

47

(8)

JAF Vol 11 No. 2 (2015) 44-48

the spatial period on the order of 1 micrometer controlled period by adjusting the microwave power. However no direct experiment can demonstrate a ponderomotive force-driven mass transport up to now. One of important tasks in this field of research is now to demonstrate a ponderomotive force-driven mass transport in a direct experiment.

IV. CONCLUSION

A nonthermal action of microwaves which enhances diffusion in solids appears to be reasonable. As follows from the theoretical and experimental results obtained for ionic crystalline solids and drying it can be viewed in terms of an additional driving force (ponderomotive force). The experimental results on microwave sintering indicate supports the theory. However no direct experiment can demonstrate a ponderomotive force-driven mass transport up to now.

REFERENSI

[1] Janney, M.A, H. Kimrey, W. Allen, J. Kiggans,1997. Enhanced diffusion in sapphire during microwave heating, J. Materials Science 32, 1347–1355. [2] Sudiana, I.N., S. Mitsudo, T.

Nishiwaki, P. E. Susilowati, L. Lestari, M. Z. Firihu, H. Aripin, Effect of Microwave Radiation on the Properties of Sintered Oxide Ceramics, Cont. Eng. Sci., Vol. 8 No. 34, 2015, pp. 1607-1615

[3] Zamrun, M F., I. N. Sudiana, Microwaves Enhanced Sintering Mechanisms in Alumina Ceramic Sintering Experiments, Cont. Eng. Sci, Vol. 9, 2016, 5, 237 – 247 [4] Rybakov, K.I. and V.E.Semenov,

Physical Review B , 52[ 5], 3030 (1995).

[5] S.A. Freeman, J.H. Booske, and R.F. Cooper, Phys. Rev. Lett., 74 [11], 2042 (1995).

[6] Sudiana, I.N, Use of Microwave Energy for Material Processing in A Simple Laboratory, Jurnal Aplikasi Fisika, Vol. 10 No. 2, Oktober 2014, Hal. 77-81.

[7] Y. L. Tian, D. L. Johnson, M. E. Brodwin, Ultrafine Microstructure of Al2O3 Produced

by Microwave Sintering, Cer. Pow. Sci. II B. pp. 925-932(1988).

[8] Sudiana, I.N, S. Mitsudo, L. O. Ngkoimani, L. Aba, H. Aripin, I. Usman, Fast Drying of Cocoa Bean by Using Microwave, CICES2014, November 10-11, 2014, Kendari, Indonesia.

[9] McMinn W. A. M., Khraisheh M. A. M., Magee T., R. A., Food Research International, 36, pp. 977-983 (2003).

[10] M.F. Ashby,First report on Sintering Diagram, Acta. Met. 22, pp.275-289(1974).

[11] K.I. Rybakov and V.E. Semenov, Materials Research Society Symposium Proceedings, Vol. 430, Pittsburgh, PA, 1996), p. 435.